Skip to content

Country

Amana - 46306 - 1/4" Composite Honeycomb Hogger

46306 - Composite Honeycomb Hogger (Solid Carbide, 6-Flute)

  • Shank: 1/4"
  • Diameter: 1/4"
  • Cutting Length: 1-1/4"
  • Overall Length: 4"
  • Max RPM: 25,000
  • Flutes: 6

Designed to cut a large variety of honeycomb materials, hogger geometry is excellent for shredding and chip evacuation while maintaining a smooth surface.

Amana Tool's "hogger" style routers for honeycomb composites incorporate a precision-ground "knuckle" profile, allowing a freer-cutting action that reduces power requirements and less sidewall pressure in low output spindles while giving impressive gains in feed-rates. ZrN coating greatly enhances durability in highly abrasive composites.

 

  • Honeycomb
  • Composite Materials
  • Acrylonitrile-Butadiene-Styrene (ABS)
  • Lexan™

 

  • Creates a harder and tougher cutting edge allows for a prolonged cutting edge life and helps to prevent the build-up of material in the flutes while cutting
  • Have the tendency to run/spin much faster than an uncoated tool
  • Optimized flute geometry and low Total Indicated Runout (TIR) guarantees clean cuts, essentially eliminates sanding and reduces chatter (where the machine or work piece vibrates) under high chip loads (when used with low TIR spindles)
  • High flute volume supports high feed rates and chip loads
  • High aspect ratio for single pass deep-reach cutting
  • Flute geometry optimized for cutting sign foam, sign board, hardwoods, thermoplastics and phenolic composites

 

For optimal results and extended tool life use mist lubricant system or air cooling.

CNC running parameters based on 1 x Diameter depth per pass:

  • RPM: 18,000
  • Feed Rate: 320 IPM
  • Chip Load per tooth: 0.003"
  • Ramp down Rate: 54 IPM
Original price $107.95 - Original price $107.95
Original price
$107.95
$107.95 - $107.95
Current price $107.95

Customer Reviews

Based on 15 reviews
93%
(14)
7%
(1)
0%
(0)
0%
(0)
0%
(0)
C
Cindy Dupere (Toronto, CA)
Great

Came in on time and in great condition

B
Bob Sparks (Toronto, CA)
Amana spiral compression bit

Excellent bit with Spectra finish, very clean cutting leaving very clean top and bottom edges on Baltic Birch plywood

D
Don Green (Tilbury, CA)
Bowl and gray bits

Look good. Haven't used them yet. Looking forward to it.