Skip to content
Gift Cards Hours & Location Milling Services Monthly Specials
HOVR Installation Bit Pack

HOVR Installation Bit Pack

The two most common bits you will need to install the HOVR bracket

If you are new to Hovr, you will need to grab a bit pack depending on your installation method. 

This pack includes:

  • 17/64" HSS Jobber Drill Bit 135" Split Point Black Oxide
    • In order to make extra holes in the female bracket, first we need a 17/64" Cobalt Jobber Drill Bit (or you can use even a 7/64 inch bit).
    • This is the bit you need to pre-drill the hole for then tapping (thread) the hole with the #18 5/16 tap bit.
    • If you are using set screws, you will need a 17/64 HSS Steel Drill Bit to drill the pilot holes for the set screws. 
  • 5/16" - 18 HSS Plug Taper Bit
    • Once we have drilled the initial hole, we then need a tapping bit. We can use a Bottoming Tap, a Plug Tap or a Taper Tap.
    • For our use, we prefer a Taper Tap Bit 5/16 Inch #18. These taps narrow a bit at the tip, therefore they can be inserted easier into the hole we drilled earlier. 
    • The 5/16" - 18 HSS Plug Taper Bit will create the threads needed for the hole. 

We recommend 3/4" Set Screws to lock in your HOVR brackets

*Please note the packaging may not be as seen

$22.95 - $22.95
$22.95
$22.95 - $22.95
$22.95

Customer Reviews

Based on 2 reviews
100%
(2)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
K
Kevin ratcliffe (Mont-Tremblant, CA)

Would have been better if I could have bought the router jig that I was told worked really well instead of having to build one

L
Lino Celestini (St. Catharines, CA)
HOVR Brackets and Bit Pack

I havent used them yet. However, I was a bit disappointed when I requred 2 6 foot
HOVR brackets and received 2 -4 foot and 2 =2 foot brackets. This is due to shipping constraints and costs.

5008
Verified Reviews

The two most common bits you will need to install the HOVR bracket

If you are new to Hovr, you will need to grab a bit pack depending on your installation method. 

This pack includes:

  • 17/64" HSS Jobber Drill Bit 135" Split Point Black Oxide
    • In order to make extra holes in the female bracket, first we need a 17/64" Cobalt Jobber Drill Bit (or you can use even a 7/64 inch bit).
    • This is the bit you need to pre-drill the hole for then tapping (thread) the hole with the #18 5/16 tap bit.
    • If you are using set screws, you will need a 17/64 HSS Steel Drill Bit to drill the pilot holes for the set screws. 
  • 5/16" - 18 HSS Plug Taper Bit
    • Once we have drilled the initial hole, we then need a tapping bit. We can use a Bottoming Tap, a Plug Tap or a Taper Tap.
    • For our use, we prefer a Taper Tap Bit 5/16 Inch #18. These taps narrow a bit at the tip, therefore they can be inserted easier into the hole we drilled earlier. 
    • The 5/16" - 18 HSS Plug Taper Bit will create the threads needed for the hole. 

We recommend 3/4" Set Screws to lock in your HOVR brackets

*Please note the packaging may not be as seen