RFT5125 - Spiral Flush Trim Up Cut
Providing state-of-the-art results in flush trimming. The bit uses a double ball bearing pilot to run against your project template while the up cut flutes pull chips up and away from the router, leaving a smooth bottom surface.
I added this bit to a recent order to qualify for free shipping and boy I'm glad I did! Turns out I needed it the very day it arrived and was not disappointed with the quality of the cutting action - very clean and smooth bearing action.
Used for cutting out handles on hardwood (hard maple, black walnut, padauk) charcuterie boards using a router table. High quality bit with only trace tearout on the underside (“up-cut” side) of the piece. Pricey but it’s a bit that should last a long time.
These work well with my Festool 125 RO in the fine mode as they leave no sanding marks compared to non festool discs.
Very satisfied....the oak grain was beautiful...milling was A1 and glued together with no problems....will buy from here again
Used the walnut for a bow, haven’t used the others yet.