Canadian manufactured C-Channel using high strength steel. The strength is achieved by using flat bar that is then folded into the C shape. Slots are laser cut into the channel at a length of 1-3/4" per slot. This is to allow a large amount of expansion and contraction.
The channel has been powder coated black to give a hard wearing finish.
Dimensions
Recommended Hardware and Fasteners
Slots per Length
The c channels were great. Sadly they were packed with the acrylic crib jig wich broke during shipping
I was making a walnut tabletop, As I was constructing it, it developed a small cup at each end, as the tabletop is a little less than one inch thick. I don’t think anyone would have noticed, but I would. Also I was worried that over time, it might get worse. I strapped on of these on on each end and it straightened it out perfectly.
good produck
This material is a game-changer in the world laser engraving! The quality of the plywood is exceptional, with a perfectly smooth, perfectly flat surface (no surprise here) that makes it a joy to work with. The finish feels a little plastic, but I understand it’s an acrylic coating over the maple fibre, which I love. Even laser-fog burn marks wipe off with a damp cloth — no masking needed. The maple grain is pronounced and it cuts cleanly and sands beautifully. 100% will purchase again.
These work well with my Festool 125 RO in the fine mode as they leave no sanding marks compared to non festool discs.
Very satisfied....the oak grain was beautiful...milling was A1 and glued together with no problems....will buy from here again